Here’s how to bleed your Brugman panel radiator

Is your radiator making annoying, bubbling sounds? Or does it no longer heat up as it should? Then it’s time to bleed your radiator and top up the water level. Fortunately, there’s no need to call in a professional. You can easily bleed your Brugman panel radiator yourself – but make sure to read this article first.

Why is it important to bleed your radiator?

Once air bubbles start to pop up in the pipes, it’s crucial to vent your radiator as quickly as possible. It will prevent the pipes from oxidising (and relieve you from those disturbing noises). Moreover, radiators use less energy when they’re working properly.

While the bubbles are not a bad thing in itself, you have every reason to check what could be wrong as bubbles can indicate a leak or other significant problems. Vent your radiator and then see if the problem persists. If that is indeed the case, it’s best to contact a professional installer. Possibly, the radiator’s expansion vessel requires repairing.

How to go about it

You only need three things to bleed your panel radiator: a screwdriver (or a venting key if you have one), a container to collect water and a large towel.

Ready? Let’s bleed!

• Step 1: Set all your radiators to the maximum temperature for at least fifteen minutes.
• Step 2: Switch the units off and let them cool for ten minutes.
• Step 3: Start with the radiator that is closest to the boiler. Close the radiator valve and place the container under the air vent to collect the water coming out in the next step.
• Step 4: Turn the air vent cap to the left using a screwdriver until no more air comes out and water starts running. Be careful not to turn open the valve entirely. If you do, there is a good chance you will no longer be able to close it afterwards.
• Step 5: Close the valve again.
• Step 6: Repeat the above steps for all the radiators in your home. Work your way up from the bottom to the top floor and only switch on the boiler again once all units have been vented.
• Step 7: Finally, check whether the pressure in the boiler is between 1.5 and 2 bar. If that is not the case, top up the water level until it is.

Are you having a hard time bleeding your Brugman radiators or are the bubbles returning rather quickly? Don’t hesitate to contact a professional installer.